Cleaning guns
Effective degreasing, washing and shampooing
JWL Cleaning gun is ideal for degreasing, washing and shampooing. The cleaning gun is easy and efficient to use and has with the handle infinitely adjustment of air.
The cleaning gun can be used with most detergents, even stronger chemicals. It is available in different variants that makes it fit exactly your task. It is possible to get the nozzles in either steel or plastic, and with suction tube or container.
- Ideal for degreasing, washing and shampooing
- For all cleaning purposes
- The service life is top-notch – even after 28 million operations
- Infinitely adjustment of the amount of fluid
- User-friendly, long-lasting and efficient
This product is suitable for
Watch Multi Cleaner in use
Multi Cleaner is ideal for cleaning air conditioners and heat pumps as well as various surfaces where cleaning and disinfection are necessary. The included extension probe makes it easy to clean hard-to-reach places. Use only with cleaning fluids or disinfectants – not acid / base.
See instructions for cleaning Air Condition systems with Multi Cleaner further down the page.
General specifications for Cleaning Guns
Technical description
 | Working pressure | Max. 6-12 bar |
 | Weight | ~0.400 kg |
| Container | 1,2 l | |
| Thread | BSP/NPT |
Materials
| Handle and trigger | Acetal plastic |
| Valve | Acetal plastic |
| Gaskets/ O-rings | Nitrile |
| Pipe and shaft | Steel, el. galvanised |
| Spring | Hardened spring wire |
Materials
| Container | PE |
| Suction tube | Nylon PA11 |
| Hoses | PVC |
| Nozzles | POM, PA6, Steel, brass |
Variants, data and accessories
Cleaning gun, plastic nozzles, 150 mm, 1.2 l container
142130-000
Cleaning gun, suction tube, plastic nozzle, 150 mm
142131-000
Cleaning gun, metal nozzle , 145 mm, 1.2 l container
142101-000
Multi Cleaner – incl. extension probe
142178-000
Accessories and spare parts for cleaning guns
| Extra metal nozzle | 142206 |
| Container 1.2 l | 143300 |
| Container with loose lid 1.2 l | 143160 |
Clean A/C systems with Multi Cleaner
Preparation and treatment of evaporator:
Dry the evaporator for 10 minutes under following conditions: A/C: off, Air Inlet: circulation, Temp.: warm, Air outlet: Foot, Fan: hi
Put a tray under evaporators drain hose and shop cloth under the cooling unit to avoid dropping on the ground and floor mat. Open windows for ventilation.
Before handling the evaporator, the ignition of the vehicle should be disconnected or turned off.
When cleaning, the vehicle should be prepared as specified in the respective operating instructions.
Insert the spray nozzle into the filter inlet or resistor opening (or another suitable inlet) and spray whole container into the evaporator while moving the nozzle around to cover the whole evaporator surface.
Once it has been sprayed on, the cleaning fluid should be allowed to act for about 15-20 minutes.
Reinstall filter and other temporarily removed parts.
To dry the treated evaporator proceed as follows: A/C: Off, Air inlet: Circulation, Temp.: warm, Air outlet: foot, Fan: hi, Time to dry: 20 – 30 minuter.
Questions about compressed air solutions?
If you have question about our blow guns, pneumatic tools or other products, then we would like to help you.
Questions about compressed air solutions?
If you have question about our blow guns, pneumatic tools or other products, then we would like to help you.
